Setup guide

./
5.-
&& .
2 Open the printer’s
front cover.
3 Slide the fuser unit out
slightly.
4 Loosen the two
screws on the
controller board panel
and, using the lip on
the left side of the
panel, pull the panel
off of the printer.
5 If you need to remove a hard disk before installing one,
remove it as follows; otherwise skip to step 5.
a Place your right hand on the metal interface plate, the thumb
on your left hand on top of the hard disk, and the other fingers
on your left hand underneath the corner of the hard disk, and
then pull up gently but firmly on the hard disk one pin at a
time. The disk is firmly seated, so it may take several tries to
remove it.
b Unplug the ribbon cable connector from its mating connector
on the controller board.


 Caution: Don’t push or pull with the ribbon cable. Use the
cable connector.

EDNord - Istedgade 37A - 9000 Aalborg - telefon [phone]