Setup guide

./
5.-






























&
$3
Only one internal IDE hard disk is supported. However, you can add
up to three external SCSI hard disks, Jaz drives, and/or Zip drives to
the printer.
-'
*
’
,-
The IDE hard disk kit includes the following:


 IDE hard disk with ribbon cable attached


 IDE hard disk bracket


 3 screws
$ '


 Caution: It's very important to protect the printer controller board and
any associated circuit boards from electrostatic damage. Before
performing this procedure, review the antistatic caution in “Antistatic
Protection” on page 5-2. In addition, always handle circuit boards by
the edges only.
When installing or removing a hard disk, ensure that the metal
support posts (on the hard disk) don’t hit any of the electrical leads on
the chips mounted on the controller board. The controller board will
not function if any of the leads are broken or shorted together.
1 Turn off the printer, and then disconnect the power cord and
all interface cables from the printer.
EDNord - Istedgade 37A - 9000 Aalborg - telefon [phone]