Setup guide

$# 
 
.
& .
"
Hard disks, Jaz drives, and Zip drives are identified by their device
numbers. If the printer has an internal hard disk, it has a device num-
ber of Dsk7. If optional external hard disks and/or drives are attached,
their device numbers can be Dsk0–Dsk4 or Dsk6. (Dsk5, which is
SCSI ID 5, is reserved for the CrownCopy scanner). Device numbers
of external hard disks and drives can be set by the installer.
»Note:
If an internal hard disk is removed or an external hard disk or
drive is not turned on, the printer does not reset nonvolatile RAM to
the factory defaults.


 Caution: If you connect to this printer an external hard disk you
previously used with an earlier QMS Crown printer (such as a QMS
2060, 2425, 4060, or
magicolor 2), this QMS magicolor 330 Print
System software release will automatically reorganize the files on the
hard disk when the printer is turned back on again. (The printer
release number is listed on both the startup and the status page.)
Once this reorganization is done, the files on the hard disk can no
longer be accessed if the hard disk is reattached to an earlier QMS
Crown printer.
This reorganization process takes time. If, when you first turn the
printer on after attaching a previously used hard disk, it does not
come on line immediately, be patient. Interrupting the reorganization
process could cause all files on the hard disk to be lost.
EDNord - Istedgade 37A - 9000 Aalborg - telefon [phone]