Setup guide
341
#
To use a QMS Kanji font SIMM you need
An application (such as a word processing or desktop publish-
ing package) that supports both the Kanji fonts and PostScript
printing.
If you’re using a Macintosh, the following Macintosh system
software:
– Macintosh OS 8.xJ
If you’re using a PC, the following system software:
– If you’re using Windows, version 3.1J or later
– If you’re using DOS, version 5.0J or later
$.*
Caution:
It's very important to protect the printer controller board and
SIMM from electrostatic damage. Before performing this procedure,
review the antistatic caution in “Antistatic Protection” on page 4-2. In
addition, always handle circuit boards by the edges only.
1 Turn off the printer, and then disconnect the power cord and
all interface cables from the printer.
2 Open the printer’s front
cover.
3 Slide the fuser unit out
slightly.
4 Loosen two screws
(one on each end of
the controller boatd panel)
and, using the tab on the
lower side of the panel,
pull the panel off.
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500