Setup guide

2!&1

+/"010$%
7 Reinstall the controller board panel on the printer.
8 Tighten the two screws.
9 Push the fuser unit back in.
10 Close the printer’s front cover.
11 Reconnect all interface cables.
12 Reconnect the power cord and turn on the printer.
»Note:
In compliance with UL guidelines, “The appliance inlet is
considered to be the main disconnect device.”
13 Print a startup page.
Check that the startup page indicates the font SIMM just installed
under “Options.”
It’s identified as
cartridge2%
.
5 Insert the font
SIMM into the
font SIMM connector.
The font SIMM
connector is smaller
than the RAM SIMM
connector. Hold the
SIMM at a 45° angle to
the controller board,
with the notch on the
right side and the
bottom edge of the
SIMM in the connector.
6 Tilt the SIMM up toward you to a 90° angle until you feel it
snap into place.
When seated, the SIMM stands upright, firmly in place.


 Caution: If you can’t snap the SIMM into place, don’t force it.
Reposition it, making sure that the bottom of the SIMM is seated
completely in the connector.
EDNord - Istedgade 37A - 9000 Aalborg - telefon [phone]