Setup guide

2!&1































*
.'0!
The QMS magicolor 330 supports 2 PCL 5 font SIMMs: the QMS
ProCollection font SIMM and the QMS Intellifont font SIMM. The
QMS ProCollection SIMM contains 65 fonts. The QMS Intellifont
SIMM contains 17 fonts.
(+*


 Caution: It's very important to protect the printer controller board and
SIMM from electrostatic damage. Before performing this procedure,
review the antistatic caution in “Antistatic Protection” on page 4-2. In
addition, always handle circuit boards by the edges only.
1 Turn off the printer, and then disconnect the power cord and
all interface cables from the printer.
2 Open the printer’s
front cover.
3 Slide the fuser unit out
slightly.
4 Loosen the two
screws on the
controller board panel
and, using the lip on
the left side of the
panel, pull the panel
off of the printer.

EDNord - Istedgade 37A - 9000 Aalborg - telefon [phone]