Setup guide

/"
&/"010$%
2 Insert the emulation disk in your PC’s 3.5" disk drive, and
change to that drive (for example, if you’re using the A drive,
type a:↵).
3 If you want to download the emulation from a UNIX worksta-
tion, copy the installation file from your PC to a temporary
directory on your workstation.
4 Turn on the printer, and wait for IDLE to appear in the mes-
sage window.
5 Open an ftp session at your PC or workstation by typing one
of the following commands:
ftp
printername ↵ (for example, ftp pctdev6↵)
ftp
ipaddress ↵ (for example, ftp 161.33.130.45↵)
6 When prompted for a user name and password, press Enter.
An ftp> prompt displays.
7 At the ftp> prompt, change to binary mode by typing
bin↵
8 At the ftp> prompt, send the emulation file to the printer’s
hard disk by typing
put
filename .ps↵
where
filename is the name of the installation file.
The printer’s message window reads 1 Active Job, and the
Disk light flashes to indicate that the emulation is being down-
loaded to the hard disk. The ftp> prompt returns when the emu-
lation has finished loading.
9 At the ftp> prompt, end the ftp session by typing
quit↵
10 When the Disk light stops flashing and the printer’s message
window reads Idle for at least 30 seconds, turn the printer
off and then on again.
EDNord - Istedgade 37A - 9000 Aalborg - telefon [phone]