Setup guide
/"
/"010$%
Caution:
It's very important to protect the printer controller board and
any associated daughterboard or module from electrostatic damage
while performing any task involving the controller board.
If an antistatic wrist strap is provided in your printer option kit,
attach one end of it to your wrist and the other end to any convenient
electrical ground (for example, the bare metal chassis of equipment,
as on the back of a computer, that is plugged in but
turned off).
Never attach the wrist strap to any piece of equipment with an
electrical current present. Turn off all power switches first. Plastic,
rubber, wood, painted metal surfaces, and telephones are not
acceptable grounding points. The printer isn't an acceptable
grounding point either because it must be unplugged before you
perform this task.
If you don't have an antistatic wrist strap, discharge your body's
static electric charge by touching a grounded surface before you
handle any printer boards or components and before removing the
controller board. Also avoid walking around after grounding yourself.
Optional emulations, such as CGM, LN03 Plus, and XES/UDK, are
available as PostScript files on floppy disks. This section describes
how to download an optional emulation to the printer’s hard disk.
»Note:
You must have at least one hard disk, internal or external,
attached to the printer in order to use an optional emulation. If more
than one hard disk is available, the emulation automatically installs
itself on the disk with the most free storage space. QMS recommends
that you have at least 4 MB of memory above the base configuration
and that you add at least 1 MB memory to each emulation installed.
This ensures that the printer can run the emulation without slowing
down performance.
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500