Setup guide
"$.#
-
6 Reinstall the controller board panel on the printer.
7 Tighten the two screws.
8 Push the fuser unit back in.
9 Close the printer’s front cover.
10 Reconnect all interface cables.
11 Reconnect the power cord and turn on the printer.
»Note:
In compliance with UL guidelines, “The appliance inlet is
considered to be the main disconnect device.”
12 Print a startup page.
Check that the time-of-day clock is listed under “Options” on the
startup page.
a Locate the time-of-
day clock socket on
the controller board
and the pin 1 notch
or printed label.
b Locate the pin 1
indicator mark on
the top of the time-
of-day clock.
This mark may be a notch or a slight depression on one end
of the clock.
c Align this indicator mark with the pin 1 notch or printed label
on the controller board.
d Gently press on the time-of-day clock until it’s firmly seated.
Caution:
Make sure that the pins on the time-of-day clock
are properly aligned with those in the receiving socket on the
controller board. Damage to the time-of-day clock and/or
controller board could result if the pins are misaligned.
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500