Setup guide
$
*
Caution:
It's very important to protect the printer controller board and
any associated circuit boards from electrostatic damage. Before
performing this procedure, review the antistatic caution in “Antistatic
Protection” on page 3-2. In addition, always handle circuit boards by
the edges only.
1 Turn off the printer, and then disconnect the power cord and
all interface cables from the printer.
2 Open the printer’s front
cover.
3 Slide the fuser unit out
slightly.
4 Loosen two screws
(one on each end of
the controller board panel)
and, using the tab on the
lower side of the panel,
pull the panel off.
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500