Setup guide

( 
#"
$%
"##"$%
8 After the new system software has been written to ROM, the
printer returns to IDLE.
»Note:
The new system image doesn’t erase the old image until
the printer verifies that the new image is valid.
9 Restart the printer to activate the new system software.
10 Print another advanced status page, and verify that the con-
figuration settings are the same.
 —!
1 Access the Administration/Miscellaneous/New System
Image menu.
2 Select Yes in the New System Image menu.
The printer automatically reboots and waits for the new system
software (image) to be sent via your PC’s parallel port.
3 Open an ftp session at your PC or workstation by typing one
of the following commands:
ftp
printername ↵ (for example, ftp pctdev6↵)
ftp
ipaddress ↵ (for example, ftp 161.33.130.45↵)
4 When prompted for a user name and password, press Enter.
An ftp> prompt displays.
5 At the ftp> prompt, change to binary mode by typing
bin↵
6 At the ftp> prompt, send the emulation file to the printer’s
hard disk by typing
put
filename .dl↵
Menu
Administration/Miscellaneous/New System Image
Choices
Yes—Download new system code
No—Don’t download new system code
Default
No
EDNord - Istedgade 37A - 9000 Aalborg - telefon [phone]