Setup guide

 !
"#































'
b Tilt the SIMM back to a 90° angle until you feel it snap into
place.
When seated, the SIMM stands straight out, firmly in place. If
you cannot snap the SIMM into place, do not force it. Reposi-
tion it, making sure that the bottom of the SIMM is seated
completely in the connector.
9 Repeat steps 7 and 8 for each additional SIMM being
installing.
10 Reinstall the controller board panel on the printer.
11 Tighten the two screws.
12 Push the fuser unit back in.
13 Close the printer’s front cover.
14 Reconnect all interface cables.
15 Reconnect the power cord, and turn on the printer.
16 Print a startup page.
Check that the startup page states the total size of the RAM
installed in your printer.
17 If necessary, refer to the advanced status page you printed in
step 1 to reconfigure printer memory.
EDNord - Istedgade 37A - 9000 Aalborg - telefon [phone]