Setup guide

 !
"#

&"##"$%
c Lift the SIMM out.
7 Remove the new SIMM from its antistatic bag.
8 Insert the new SIMM into the SIMM connector.
a Hold the SIMM at a 45° angle to the controller board, with the
notch on the right side and the bottom edge of the SIMM in
the connector.
»Note:
You can insert a SIMM in any SIMM connector as long
as DRAM0 and the SIMM connector before the one you’re
installing are occupied.
EDNord - Istedgade 37A - 9000 Aalborg - telefon [phone]