Setup guide
!
"#
4 Slide the fuser unit out slightly.
5 Loosen the two screws on the controller board panel
and, using the lip on the left side of the panel, pull the
paneloff of the printer.
6 If you need to remove a SIMM before installing one,
remove it as follows; otherwise skip to step 7.
»Note:
If all the SIMM connectors are filled and you want to install
more memory, you have to exchange one or more SIMMs for
SIMMs with a greater memory capacity.
a Using both thumbs, pull the latches (one on each side of the
SIMM connector) outward.
b Tilt the SIMM forward to a 45° angle away from the SIMM
connector.
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500