Setup guide

 !
"#

"##"$%
/0

Single in-line memory modules (or SIMMs) are compact circuit
boards with surface-mount memory chips.
Your QMS
magicolor 330 Print System comes with the following
printer memory:


 QMS
magicolor 330 CX Print System—64 MB RAM


 QMS
magicolor 330 EX Print System—192 MB RAM
However, you can upgrade either of these models to a maximum of
384 MB of RAM through the installation of additional SIMMs.
Additional memory allows you to download more fonts and increase
the printer’s buffer (area where data sent from the computer is stored
while waiting to be printed).



 Caution: It's very important to protect the printer controller board and
SIMM from electrostatic damage. Before performing this procedure,
review the antistatic caution in “Antistatic Protection” on page 2-2.
Always handle circuit boards by the edges only.
1 In case you need to restore any memory settings after the
SIMM installation, print an advanced status page.
»Note:
Installing SIMMs automatically restores defaults. If your
memory settings are specific to your environment, print an
advanced status page before installing SIMMs, so you can
recover the current memory settings.
2 Turn off the printer, and then disconnect the power cord and
all interface cables from the printer.
3 Open the printer’s front cover.
EDNord - Istedgade 37A - 9000 Aalborg - telefon [phone]