User`s guide

Configuring the TCP/IP
Protocol
QMS CrownNet System Administrator's Guide2-54
Printing an LPD Banner Page
This menu allows you to print a banner page after an LPD print job.
Disabling the BOOTP Protocol
The BOOTP menu allows you to enable or disable the BOOTP proto-
col.
Menu Administration/Communications/Resident NIC/CrownNet/
TCPIP/LPD Banner
Administration/Communications/Optional NIC/CrownNet/
TCPIP/LPD Banner
Choices Enabled—Print a banner page after the job.
Disabled—Do not print the banner page.
Default Enabled
Effectivity Changes to this menu take effect immediately.
Menu Administration/Communications/Resident NIC/CrownNet/
TCPIP/Protocol/BOOTP
Administration/Communications/Optional NIC/CrownNet/
TCPIP/Protocol/BOOTP
Choices Enabled—Enables the BOOTP protocol.
Disabled—Disables the BOOTP protocol.
Default Enabled
Effectivity The CrownNet interface must be reset for changes to take
effect. Use the Administration/Communications/
xxxxxxxx NIC/
CrownNet/Common/Soft Reset menu (where
xxxxxxxx is
either Resident or Optional).