User`s guide

Configuring the TCP/IP

Protocol

QMS CrownNet System Administrator's Guide2-46

n Accnting/Revchan—Allows you to enable TCP/IP accounting

and reverse channel (backchannel) information.

n Accnting Timeout—Allows you to set the amount of time the

CrownNet interface waits for a terminating acknowledgment from

the host before allowing another connection.

n Port Assignment—Allows you to set the port that is used for

TRANSPORT1/STATUS1 communications.

n LPD Banner—Allows you to print a banner page after an LPD

print job.

n BOOTP—Allows you to disable bootp protocol.

n RARP—Allows you to disable rarp protocol.

n SNMP NMS 1-SNMP NMS 5—Allows you to configure SNMP

(Simple Network Management Protocol), a protocol used to mon-

itor devices, the networks to which they attach, and the network

management stations (NMSs) to which SNMP data is reported.

Enabling the TCP/IP Protocol

The Protocol menu allows you to enable or disable the TCP/IP proto-

col.

Menu Administration/Communications/Resident NIC/CrownNet/

TCPIP/Protocol

Administration/Communications/Optional NIC/CrownNet/

TCPIP/Protocol

Choices Enabled—Enables the TCP/IP protocol.

Disabled—Disables the TCP/IP protocol.

Default Enabled

Effectivity The CrownNet interface must be reset for changes to take

effect. Use the Administration/Communications/

xxxxxxxx

NIC/

CrownNet/Common/Soft Reset menu (where

xxxxxxxx

either Resident or Optional).