User`s guide

Configuring the NetWare
Protocol
2-41
Printer Interface Configuration
Specifying a Printer Name
The Printer Name menu allows you to specify a name by which the
printer is known on the network. Four options are available:
n Printer Name 1
n Printer Name 2
n Printer Name 3
n Default
» Note:
This name will only make the printer name known to
CrownAdmin 3 network utility.
Specifying Printer Name 1, Printer Name 2,
and Printer Name 3
The Printer Name 1, Printer Name 2, and Printer Name 3 options
allow you to specify a name of the printer known to CrownAdmin 3.
» Note:
The three Name options allow you to set only a single printer
name up to 47 characters in length. See the “Guidelines,” below.
Menu Administration/Communications/Resident NIC/CrownNet/
NetWare/Printer Name/Name 1, Name 2, Name 3
Administration/Communications/Optional NIC/CrownNet/
NetWare/Printer Name/Name 1, Name 2, Name 3
Choices Up to 47 characters (see “Guidelines,” below)
Default QMS_xxxx_Print_System_hardwareaddress, where
xxxx is the printer model number and hardwareaddress is
the printer’s hardware address as found on the printer start-up
page.
Effectivity When the printer is placed back online.
Notes Use the Administration/Communications/
xxxxxxxx NIC/
CrownNet/NetWare/Printer Name/Default menu (where
xxxxxxxx is either Resident or Optional) to reset the printer
name to the default.
No two printers on the network may have the same name.