User`s guide

Updating
CrownNet
Software
9-17
Troubleshooting
PC and UNIX Procedure
1 Insert the CrownNet upgrade CD-ROM in the computer’s CD-
ROM drive.
» Note:
On UNIX systems you may have to mount the CD drive
before using the CD-ROM. Go to the root directory and make a
directory for the CD-ROM. Mount the CD-ROM file system by
typing one of the following commands:
nn For AIX, type mount -o ro -v cdrfs
device_filename /cdrom↵
nn For HP-UX, type mount -t cdfs
device_filename
/cdrom↵
nn For SunOS, type mount -r -t hsfs
device_filename /cdrom↵
2 Download the new CrownNet software PostScript
XXXXXXXX .PS file (the name of the file varies) to the printer
any way you would normally send a PostScript file. A
“ReadMe” file on the root directory of the CD-ROM will show
you where the file is located on the CD-ROM.
For example, you might use QMS CrownAdmin 3, QMS PS Exec-
utive, copy /b, or fstprn from a PC, or qpr or put from a UNIX
system. (PS Executive is a printer utility shipped with every QMS
printer. Refer to your printer documentation, if necessary, for
installation instructions.)
The downloading process takes at least 5 minutes.
uu Caution: Once you’ve sent the PostScript file to the printer,
do not turn the printer off and on again until you’ve waited
at least 5 minutes even if the message window reads
Idle .
After the file is downloaded, it takes time for the hardware to be
reprogrammed. Interrupting this process will cause unexpected
results.