User`s guide

Updating
CrownNet
Software
QMS CrownNet System Administrator's Manual9-16
6 Select the new CrownNet software PostScript XXXXXXXX.PS
file (the name of this file varies), and choose Send.
A “ReadMe” file on the root directory of the CD-ROM shows you
where the file is located on the CD-ROM.
The downloading process takes about 5 minutes.
uu Caution: Once you’ve sent the PostScript file to the printer,
do not turn the printer off and on again until you’ve waited
at least 5 minutes even if the message window reads
Idle .
After the file is downloaded, it takes time for the hardware to be
reprogrammed. Interrupting this process will cause unexpected
results.
7 After at least 5 minutes, if the printer doesn’t reboot auto-
matically, turn it off and then on again.
nn Printers with a hard disk attached usually must be rebooted
manually.
nn Printers without a hard disk reboot automatically.
nn Older printers with a hard disk may have to be turned on and
off twice.
8 Print another CrownNet configuration page (the Administra-
tion/Communications/
xxxxxxxx NIC/CrownNet/Common/
Config Page menu, where
xxxxxxxx is either Resident or
Optional)), and check the CrownNet software version num-
ber to verify successful installation of the upgrade.
9 If necessary, use the CrownNet configuration page you
printed before you downloaded the new software to
reconfigure the interface to its previous settings.