User`s guide

EtherTalk
Problems
9-5
Troubleshooting
2 After logging into the remote host, set the remote
environment to port display messages to the local host’s IP
address by typing
setenv DISPLAY
local_host’s_IP_address :0.0
For example, if the local host’s IP address is 161.33.131.151,
you would type setenv DISPLAY 161.33.131.151:0.0
EtherTalk Problems
EtherTalk icons are missing from the Control Panel.
nn Reinstall the EtherTalk software that came with your computer’s
Ethernet board.
The printer doesn’t appear in the Chooser.
nn Is the printer connected to the network?
nn Is the printer plugged in and turned on?
nn Is the cable correctly connected to the CrownNet interface port
(and, if necessary, correctly terminated)?
Network services don’t appear in the Chooser.
nn Is the Macintosh connected to the network?
nn Is the cable correctly connected to the Macintosh’s Ethernet
board (and, if necessary, correctly terminated)?
nn Are there earlier versions of EtherTalk running on your network?
nn Is the Chooser open while you are working in the Control Panel?
If you switch the network connection in the Control Panel while
the Chooser is open, the network information in the Chooser may
not be updated. Close the Chooser and reopen it to see the net-
work information.