User`s guide

installed and used in accordance with the user documentation, may
cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and the
receiver.
3. Connect the equipment to an outlet on a circuit different from
that to which the receiver is connected.
4. Consult the dealer or an experienced/TV technician for help.
WARNING!
To prevent electrical shock, do not remove any
covers from your printer unless you are a qualified QMS
service technician.
ACHTUNG!
Zur Vermeidung von Verletzungen durch
Stromschläge dürfen die Abdeckungen im Drucker nicht ent-
fernt werden. Dies sollte nur bei Bedarf durch einen QMS
Servicetechniker erfolgen.
CAUTION: Any modifications or changes to this product not
expressly approved in writing by the manufacturer responsible for
compliance to Federal Regulations could void the user’s authority
to operate this product within the Laws and Regulations of the
Federal Communications Commission.
NOTE: A shielded cable is required to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC
rules.
Appendix G
G-2 Manual Notices