User`s guide

4. With pin 1 (indicated by a dot in fig. 8.29) away from you,
insert the 220-ohm SIP resistor pack prongs in the RN5
socket; then insert the 330-ohm SIP resistor prongs in the RN4
socket (fig. 8.29).
5. Follow the instructions in the “Replacing the Printer and
Controller Board” section earlier in this chapter, being careful
to follow the directions for eliminating static.
6. Use the 50-pin to 36-pin cable included in your kit to connect
the Dataproducts cable to the parallel port.
..................
..................
..................
..................
Fig. 8.29 Insert the SIP Resistors
Chapter 8
8-47 Printer Options