User`s guide

■ An anti-static wristband
■ Two 2-pin shunts (small plastic pieces lined with metal)
■ Two SIP (single in-line package) resistors (a 220 ohm and
a 330 ohm)
■ Two DIP (dual in-line package) resistors (not necessary
for this procedure)
■ A 50-pin to 36-pin cable
1. Follow the instructions in the “Removing the Controller
Board and Printer Covers” section earlier in this chapter,
being careful to follow the directions for eliminating static
before you begin.
2. Face the controller board so that the side where the SIMMs
are is closest to you and the parallel port is located on your
right side.
Chapter 8
8-45 Printer Options