User`s guide

4. Snap the daughterboard on the two support posts and the two
48-pin connectors (fig. 8.26). The daughterboard is notched
(keyed) so that it fits only one way.
5. Replace the controller board and printer covers by following
the steps in the “Replacing the Controller Board and Printer
Covers” section found earlier in this chapter.
6. Remove the screws from the optional interface plate on the
back of the printer and save for reuse later or discard.
..................
..................
..................
..................
.......................
.......................
...................
...................
...................
...................
Fig. 8.26 Install the Daughterboard
Chapter 8
Printer Options 8-42