User`s guide

2. Follow the steps in the “Removing the Printer and Controller
Board Covers” section of this chapter to access the controller
board.
3. Install the two support posts that came with the daughterboard
into the two holes on the controller board. The support posts
have a larger diameter at one end and are tapered at the other
end. Snap the ends with the larger diameter in the controller
board (fig. 8.25). You may need a tool to hold the posts
together enough to get them into the controller board holes.
..................
..................
..................
..................
.......................
.......................
...................
...................
...................
...................
Fig. 8.25 Install Support Posts on Controller Board
Chapter 8
8-41 Printer Options