User`s guide

Number of kilobytes of RAM to be used by non-PostScript
emulations for storing downloaded (“soft”) fonts, forms, or
macros. Data in this client disappears when the printer is turned
off. This client is listed as Temporary on the status page. Increasing
this client’s memory increases the amount of PCL downloaded
fonts which can be accepted.
K Mem Display (5 digits; default 00192; range 00192-12288)
Number of kilobytes of RAM dedicated to the display lists. The
display list holds the intermediate representation of pages to be
printed.
K Mem Framebuff (5 digits; default 04080; range 02160-65536)
Number of kilobytes of RAM dedicated to the frame buffers. The
amount of frame buffer storage affects the maximum complexity
of any single page.
K Disk Cache (5 digits; default 00128; range 00032-02048)
Number of kilobytes of RAM dedicated to the disk cache. This
memory client speeds file system throughput on the optional hard
disks.
The amount of memory needed for this memory client depends on
the size of the disks, the number of disks, the number of
subdirectories on each disk, and the desired number of available
disk cache blocks. If sufficient memory is available, all disks are
accessible. If there is insufficient memory available, some disks
may be accessible and others may not and/or an insufficient number
of disk cache blocks may be available.
Determine the recommended disk cache client size as follows:
Chapter 4
4-44 Printer Configuration