User`s guide

None PostScript ^D (CTRL D) command
QMS EOD %%EndOfDocument
HP EOD <ESC>%-12345X
PS Protocol (default normal; range normal, normal fixed, binary,
binary fixed)
Sets the binary communications protocol (BCP) for
communicating over a parallel interface to a PostScript
printer. See appendix F, “Additional Technical
Information,” for more information.
Normal Enables standard, ASCII hex proto-
col. Data is sent and received in ASCII
format. This mode is recommended if
you do not print binary data. It was
designed for data in the printable AS-
CII range. Print jobs can alter the PS
protocol value through PostScript op-
erators.
Normal
Fixed
Enables standard, ASCII hex proto-
col. Print jobs can not alter this value
through PostScript operators.
Binary Enables binary communications pro-
tocol. Print jobs can alter this value
through PostScript operators. Data in
the printable ASCII range also prints.
Binary
Fixed
Enables binary communications pro-
tocol. Print jobs can not alter this
value through PostScript operators.
Data in the printable ASCII range also
prints.
Administration / Communications / AppleTalk Sets the
AppleTalk interface values used for printer-host communication.
Mode (default enabled; range enabled, disabled) Enables or
disables the communication interface. You must turn
the printer off and back on again before changes take
effect.
Chapter 4
4-30 Printer Configuration