Specifications


%# ')
# 
The K Mem Emulation, listed on the status page as Emulation, is the number of kilo-
bytes of RAM to be used by non-PostScript emulations for temporary storage and for
loading optional emulations.
# 9:
The K Mem Emul Temp, listed on the status page as Emulation Temporary, is the
number of kilobytes of RAM to be used by non-PostScript emulations for storing
downloaded (soft) fonts, forms, or macros.
Menu
Administration/Memory/Manual Config/K Mem Emulation
Purpose
Sets the number of kilobytes of RAM to be used by non-PostScript
emulations for temporary storage and for loading optional emulations.
Choices
0-99999
Notes
If you receive an emulation error, you may need to increase the amount of
memory for this client. The maximum value listed depends on the amount
of memory installed.
If you change the K Mem Emulation value, the printer automatically
restarts after you save your changes and exit from the configuration
menu.
Menu
Administration/Memory/Manual Config/K Mem Emul Temp
Purpose
Sets the number of kilobytes of RAM to be used by non-PostScript
emulations for storing downloaded (soft) fonts, forms, or macros.
Choices
0-99999
Notes
This value must be greater than the sum of the Min K Spool for all
installed and enabled interfaces. Data in this client disappears when the
printer is turned off. Increasing this client’s size increases the number of
PCL downloaded fonts which can be accepted. The maximum value listed
depends on the amount of memory installed.
If you change the K Mem Emul Tmp value, the printer automatically
restarts after you save your changes and exit from the Configuration
menu.
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500