Specifications


%# ''
0# 
The K Mem for Spool, listed on the status page as Host Input, is the total number of
kilobytes of RAM allocated to all spooling buffers. This memory client stores incoming
data from the various interfaces until it is processed and printed.
Menu
Administration/Memory/Manual Config/K Mem for Spool
Purpose
Sets the total number of kilobytes of RAM allocated to all spooling buffers,
which store incoming data from the various interfaces until it is processed
and printed.
Status Page
Equivalent
Host Input
Choices
00000-99999
Notes
This value must be greater than the sum of the Min K Spool for all
installed and enabled interfaces. The maximum value listed depends on
the amount of memory installed.
When the sum of the Min K Spool for all interfaces is less than K Mem for
Spool, memory is allocated as follows:

Interfaces with Min K Spool (in the Administration/Communications
menu) value greater than zero receive their specified allocation.

The remaining memory in K Mem for Spool is allocated to Shared
Spooling Space. This can be seen in the Communications Settings &
Input Buffer Sizes area of the status page.

The Shared Spooling Space can be allocated to any of the communi-
cation interfaces if the input jobs require more spooling space. The
limit to this is the amount of Host Input (K Mem for Spool) shown on
the status page.
»Note:
If you add the Input Buffer Sizes allocated to each interface
and the Shared Spooling Space, the result should equal Host
Input.
If you change the K Mem for Spool value, the printer automatically
restarts after you save your changes and exit from the configuration
menu.
EDNord - Istedgade 37A - 9000 Aalborg - telefon [phone]