Specifications

,$#

"1)2/
This section contains the configuration choices available under Emulations/HP-GL.
 
Identifies the HP-GL plotter type.
 
Identifies the percentage to reduce or enlarge an image.
Menu
Administration/Emulations/HP-GL/Plotter
Choices
7475A—
7470A—
Colorpro—
7550A—
DraftMaster—Supports architectural and engineering paper sizes (for
example, A to E and Arch A to Arch E). These paper sizes describe a
mapping to the physical paper. This mapping is a scaling factor (or a size
ratio) between the chosen paper size and the physical paper size in the
default inputbin. For example if A3 is selected (size 11.69'' x 16.54'') for
paper size and the physical paper size in the default inputbin is A4 (8.27''
x 11.69''), then the plot is scaled by a factor of 2.
Default
7550A
Menu
Administration/Emulations/HP-GL/Scaling Percent
Choices
001-150 (1-150%)
Default
100 (100%)
Notes
To scale plots, select the paper size originally used for the plot in the
Paper Type menu and then enter the reduction or enlargement needed to
fit the plot on the new page in the Scaling Percent menu.
EDNord - Istedgade 37A - 9000 Aalborg - telefon [phone]