Specifications


#$!"#$# '
The recommended amount of memory for the disk cache client for all disk drives is as
follows:
 45 KB internal usage
 0.5 KB per MB of disk storage total for all disks
 120 KB of memory dedicated to caching
For example, the recommended amount of memory for the disk cache for a single 120
MB hard disk would be 208 KB, and for two 120 MB hard disks it would be 268 KB.
!!
This field on the status page shows the size of the physical RAM installed in the
printer. If a hard disk is installed and disk swapping is enabled (Administration/Mem-
ory/Manual Config/Enable Disk Swap), this field also gives the size of available virtual
memory.
!
Also known as System Use, this non-configurable client is the amount of RAM used to
run the printer’s operating system. It’s never increased or decreased. The system
memory subtracted from the total amount of RAM identifies the amount of RAM avail-
able for all the other memory clients.
1!
You can add one internal IDE hard disk (standard on QMS 3260/4032 EX model) and
up to three optional SCSI hard disks, to your QMS 3260/4032 Print System. These
hard disks serve as secondary storage places for such items as downloaded fonts,
emulations, and spooled data.
»Note:
See FAQ 7181 for a list of each approved hard disk, its manufacturers and part
numbers, and the QMS products on which it can be used. You can access QMS FAQs
through the QMS SupportBase at http://www.qms.com/support/supportbase or
through Q-FAX. See appendix A, “QMS Customer Support,” to find out how to access
Q-FAX documents. (FAQ numbers may be subject to change, so you may want to
obtain a directory of Q-FAX documents before requesting a specific document.)
;# !#
When a hard disk is installed and disk swapping is enabled (Administration/Memory/
Enable Disk Swap menu), your printer supports virtual memory capabilities for all
EDNord - Istedgade 37A - 9000 Aalborg - telefon [phone]