Service manual
5-10 QMS 3260/4032 Laser Printer - Base Engine Technical Manual
Release Version 11-97
Primary Fault Isolation Procedures
4
IMAGE DEVELOPMENT INSPECTION
1. Remove the Rear Cover (RRP 1.3).
2. Generate a Grid Test Print and switch OFF printer power
halfway through the print cycle.
3. Open the Left Upper Cover.
4. Open the Drum Shutter.
5. Hand rotate (counter clockwise) the Main Drive Motor to
advance the Drum far enough so you can see the devel-
oped image area on the Drum before
it reached Transfer.
Is the image on the drum completely developed; with
sharp, black, easily read areas and clear, white areas?
Replace the
BTR Assem-
bly (RRP 5.3)
Go to step 5
Step Actions and Questions Yes No