Service manual

FEDERAL COMMUNICATIONS COMMISSION NOTICE
This equipment has been tested and found to comply with the limits set for a Class B digital
device, as stated in Part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a commercial installation. This equipment generates,
uses, and can radiate radio frequency energy. If not installed and used in accordance with the
instructions provided, this equipment may cause disruptive interference to nearby radio and
television communications. Even if the equipment is installed according to the instructions,
there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause disruptive interference to nearby radio and television reception, switch the equip-
ment off to determine if it is the true cause of the interference. If the equipment is the cause of
the interference, the user should try to minimize the interference by using one or more of the fol-
lowing actions:
• Either re–orient or relocate the radio/television receiving antenna.
• Increase the separation between the equipment and the radio/television receiver.
• Connect the equipment to an AC outlet that is not on the same circuit as the radio/television
receiver.
• If the previous solutions fail to bring results, you should consult either your equipment
dealer or an experienced radio/television technician.
For more information on interference, refer to the Federal Communications Commission’s book-
let “How to Identify and Resolve Radio-TV Interference Problems”. This booklet is available
from the U.S. Government Printing Office, Washington D.C. 20402, Stock No. 004-000-00345-4.
Modifications
Changes or modifications to this equipment not expressly approved by QMS, Inc. may void the
user's right to operate the equipment.