Service manual

QMS 3260/4032 Laser Printer - Base Engine Technical Manual 10-141
Release Version 11-97
Removal and Replacement Procedures
RRP 9.5 Noise Filter PWB (PL 11.1)
Removal
1. Remove the Rear Cover
(
RRP 1.3
)
.
2. Disconnect J19, F55, and F56 from the Noise Filter PWB.
3. Remove the two screws securin
g
the Noise Filter PWB to the printer frame.
4. S
q
ueeze the two latches securin
g
the PWB to the printer frame, and remove the PWB.
Replacement
1. Ali
g
n the two holes in the left side of the Noise Filter PWB with the two plastic latches on the printer
frame, and press the PWB into place.
2. Use two screws to secure the Noise Filter PWB to the printer frame.
3. Reconnect J19, F55, and F56 to the Noise Filter PWB.
4. Reinstall the Rear Cover
(
RRP 1.3
)
.