Service manual

QMS 3260/4032 Laser Printer - Base Engine Technical Manual 10-133
Release Version 11-97
Removal and Replacement Procedures
RRP 9.1 Main Power Switch (PL 11.1)
Removal
1. Remove the Top Cover Assembl
y
(
RRP 1.2
)
.
2. Remove the screw securin
g
the Main Switch Bracket to the Power Suppl
y
Assembl
y
.
3. Pull the Bracket and Switch up and awa
y
from the Power Suppl
y
.
4. Disconnect the four wires from the Switch.
5. S
q
ueeze the two clips on the underside of the Switch while
y
ou slide the Switch out the top of the
Bracket.
Replacement
1. Slide the Main Switch into the openin
g
in the top of the Main Switch Bracket.
It snaps into place.
2. Reconnect the four wires to the Switch.
Follow the illustration below when reconnectin
g
the wires. The illustration represents the underside of
the Main Switch Bracket and Main Switch.
3. Reinstall the Main Switch Bracket onto the Power Suppl
y
Assembl
y
.
Make sure
y
ou ali
g
n the screw hole in the Bracket with the screw hole in the Power Suppl
y
.
4. Use one screw to secure the Bracket to the Power Suppl
y
Assembl
y
.
5. Reinstall the Top Cover Assembl
y
(
RRP 1.2
)
.
SR1010X