Service manual
QMS 3260/4032 Laser Printer - Base Engine Technical Manual 10-127
Release Version 11-97
Removal and Replacement Procedures
RRP 7.11 Inverter Clutches (PL 9.4)
Removal
1. Remove the Exit Drive Assembl
y
(
RRP 7.2
)
.
2. Remove the four screws securin
g
the Drive Support to the Inverter Bracket, and lift the Support off of
the Bracket.
3. Disconnect P/J 218 and P/J 219, and free the wire harness from the harness clips.
4. Slide the CCW Gear off of the CCW Clutch.
5. Slide the CW Gear off of the CW Clutch.
6. Lift the CCW Clutch off of the bearin
g
, and remove the Clutch.
7. Lift the CW Clutch off of the bearin
g
, and remove the Clutch.
Replacement
1. Reinstall the two bearin
g
s into the cutouts in the Inverter Bracket.
2. Position the CW Clutch so the
g
ear faces awa
y
from the Bracket, and insert the shaft at the rear of the
Clutch into the bearin
g
.
Make sure the notch in the Clutch hooks onto the tab on the Bracket.
(
Refer to the fi
g
ure for correct
positionin
g)
.
3. Position the CCW Clutch so the
g
ear faces awa
y
from the Bracket, and insert the shaft at the rear of
the Clutch into the bearin
g
.
Make sure the notch in the Clutch hooks onto the tab on the Bracket.
(
Refer to the fi
g
ure for correct
positionin
g)
.
4. Reinstall the CW Gear onto the CW Clutch shaft.
5. Reinstall the CCW Gear on to the CCW Clutch shaft.
6. Route the wire harness under the harness clips and reconnect P/J 218 and P/J 219.
7. Carefull
y
reinstall the Drive Support onto the Inverter Bracket, makin
g
sure the Clutch shafts fit into the
bearin
g
s in the Support.
8. Use four screws to secure the Drive Support to the Inverter Bracket.
9. Reinstall the Exit Drive Assembl
y
(
RRP 7.2
)
.