Service manual

QMS 3260/4032 Laser Printer - Base Engine Technical Manual 10-125
Release Version 11-97
Removal and Replacement Procedures
RRP 7.10 Full Stack Sensor (PL 9.3)
Removal
1. Remove the Fuser Full Cover
(
RRP 1.1
)
.
2. Disconnect J133 and remove the wire harness from the harness clips.
3. S
q
ueeze the latches to unlock the Full Stack Sensor, and remove the Sensor from the Offset Assem-
bl
y
.
Replacement
1. Reinstall the Full Stack Sensor b
y
pressin
g
the Sensor latches into the cutouts in the Offset Assembl
y
.
Make sure
y
ou install the Sensor with the wire positioned to the rear of the Offset Assembl
y
, and the
Sensor actuator movin
g
freel
y
throu
g
h the cutout below the Sensor.
2. Reconnect J133 and secure the wire harness under the harness clips.
3. Reinstall the Fuser Full Cover
(
RRP 1.1
)
.