Service manual

QMS 3260/4032 Laser Printer - Base Engine Technical Manual 10-123
Release Version 11-97
Removal and Replacement Procedures
RRP 7.9 Exit Roll Assembly (PL 9.2)
Removal
1. Remove the Exit Drive Assembl
y
(
RRP 7.2
)
.
2. Remove the two screws securin
g
the Face Up Lower Chute to the Assembl
y
frame, and remove the
Chute.
3. Remove the K clip securin
g
the Gear located at the rear of the Exit Roll shaft, and remove the Gear
and rear bearin
g
.
4. Remove the E rin
g
securin
g
the front of the Exit Roll shaft to the Assembl
y
frame, and remove the front
bearin
g
.
5. Slide the shaft to the rear, and remove the shaft from the Assembl
y
.
Replacement
1. Reinstall the Exit Roll Assembl
y
b
y
slidin
g
the rear of the shaft throu
g
h the bearin
g
cutout at the rear of
the Assembl
y
frame.
2. Slide the front of the shaft into the bearin
g
cutout at the front of the Assembl
y
frame.
3. Reinstall both front and rear bearin
g
s.
4. Use an E rin
g
to secure the front of the shaft.
5. Slide the Gear onto the rear of the shaft and use a K clip to secure the Gear.
6. Reinstall the Face Up Lower Chute, and use two screws to secure it to the Assembl
y
frame.
7. Reinstall the Exit Drive Assembl
y
(
RRP 7.2
)
.