Service manual

QMS 3260/4032 Laser Printer - Base Engine Technical Manual 10-121
Release Version 11-97
Removal and Replacement Procedures
RRP 7.8 Upper Chute Assembly (PL 9.3)
Removal
1. Remove the Offset Roller Assembl
y
(
RRP 7.6
)
.
2. Disconnect P/J 133 and free the wire harness from the harness clips.
3. Disconnect P/J 210 and free the wire harness from the harness clips.
4. Open the Upper Chute Assembl
y
and loosen, do not remove, the rear screw securin
g
the Face Up
Lower Chute to the frame.
5. Remove the three rear screws that secure the Lower Chute to the frame.
6. Carefull
y
pull the frame far enou
g
h to the rear to free the rear hin
g
e of the Upper Chute.
7. Pull the Upper Chute to the rear and free the front hin
g
e and remove the Upper Chute Assembl
y
.
Replacement
1. Reinstall the front hin
g
e of the Upper Chute Assembl
y
into the cutout at the front of the frame.
2. Carefull
y
pull the frame far enou
g
h to the rear so
y
ou can slip the rear hin
g
e of the Upper Chute into
the cutout at the rear of the frame.
3. Use three screws to secure the Lower Chute to the frame.
4. Open the Upper Chute Assembl
y
and ti
g
hten the rear screw securin
g
the Face Up Lower Chute to the
frame.
5. Reconnect P/J 210 and route the wire harness under the harness clips.
6. Reconnect P/J 133 and route the wire harness under the harness clips.
7. Reinstall the Offset Roller Assembl
y
(
RRP 7.6
)
.