Service manual

QMS 3260/4032 Laser Printer - Base Engine Technical Manual 10-115
Release Version 11-97
Removal and Replacement Procedures
RRP 7.5 Face Up Exit Sensor (PL 9.1)
Removal
1. Remove the Fuser Full Cover
(
RRP 1.1
)
.
2. Disconnect J109.
3. Remove the two screws securin
g
the Face Up Exit Sensor to the Exit Sensor Bracket and remove the
Sensor.
4. Remove the two screws securin
g
the Exit Sensor Bracket to the Lower Chute, and remove the
Bracket.
5. Unhook the Exit Sensor Sprin
g
from the Bracket, and remove the Exit Sensor Actuator.
Replacement
1. Reinstall the Exit Sensor Actuator onto Exit Sensor Bracket.
2. Hook the Exit Sensor Sprin
g
onto the Bracket.
3. Reinstall the Bracket onto the Lower Chute, and use two screws to secure the Bracket.
4. Reinstall the Face Up Exit Sensor onto the Bracket, and use two screws to secure the Sensor.
5. Reconnect J109.
6. Reinstall the Fuser Full Cover
(
RRP 1.1
)
.