Service manual

QMS 3260/4032 Laser Printer - Base Engine Technical Manual 10-111
Release Version 11-97
Removal and Replacement Procedures
RRP 7.3 Exit Gate Solenoid (PL 9.1)
Removal
1. Remove the Fuser Full Cover
(
RRP 1.1
)
.
2. Disconnect J210 from the Exit Gate Solenoid.
3. Remove the wire harness from the harness clips.
4. Remove the two screws securin
g
the Exit Gate Solenoid to the Offset Assembl
y
, and remove the Sole-
noid.
Replacement
1. Position the Exit Gate Solenoid so the wire harness faces up.
2. Reinstall the Solenoid onto the Offset Assembl
y
, makin
g
sure the crossbar of the solenoid plun
g
er
latches onto the Solenoid Link.
3. Use two screws to secure the Solenoid to the Assembl
y
.
4. Reconnect J210.
5. Secure the wire harness to the harness clips.
6. Reinstall the Fuser Full Cover
(
RRP 1.1
)
.