Service manual

QMS 3260/4032 Laser Printer - Base Engine Technical Manual 10-109
Release Version 11-97
Removal and Replacement Procedures
RRP 7.2 Exit Drive Assembly (PL 9.4)
Removal
1. Remove the Offset Unit Assembl
y
(
RRP 7.1
)
.
2. Remove the three screws securin
g
the Exit Drive Assembl
y
to the Offset Unit Assembl
y
.
3. Pull the Exit Drive Assembl
y
strai
g
ht out and awa
y
from the Offset Unit.
Replacement
1. Ali
g
n the Exit Drive Assembl
y
with the Offset Unit Assembl
y
so the white drive
g
ear and shaft fit
throu
g
h the correspondin
g
openin
g
in the Exit Drive Assembl
y
.
2. Press the Exit Drive Assembl
y
onto the Offset Unit, sli
g
htl
y
repositionin
g
the Assembl
y
so the position-
in
g
pin on the upper ri
g
ht side of the Offset Unit fits throu
g
h the correspondin
g
hole in the Exit Drive
Assembl
y
.
Make sure
y
ou do not trap an
y
wire harnesses between the Exit Drive Assembl
y
and the Offset Unit
Assembl
y
.
3. Use three screws to secure the Exit Drive Assembl
y
to the Offset Unit Assembl
y
.
4. Reinstall the Offset Unit Assembl
y
(
RRP 7.1
)
.