Service manual

QMS 3260/4032 Laser Printer - Base Engine Technical Manual 10-107
Release Version 11-97
Removal and Replacement Procedures
RRP 7.1 Offset/Exit Assembly (PL 9.1 ~ 9.3)
Removal
1. Remove the Fuser Full Cover
(
RRP 1.1
)
.
2. Remove the Rear Cover Assembl
y
(
RRP 1.3
)
.
3. Open the Duplex Unit.
4. Open the Upper Left Cover.
5. Remove J104, J209, J601, and J602 from the Offset Unit Assembl
y
.
6. Remove the three screws
(
one screw at the front of the Assembl
y
, next to the solenoid, and two
screws at the rear of the Assembl
y)
securin
g
the Offset Unit to the printer frame.
7. Lift the Offset Unit up and off of the printer frame.
Replacement
1. Open the Duplex Unit.
2. Open the Upper Left Cover.
3. Reinstall the Offset Unit onto the printer frame.
4. Use three screws
(
one screw at the front of the Assembl
y
, next to the solenoid, and two screws at the
rear of the Assembl
y)
to secure the Offset Unit to the printer frame.
5. Reconnect J104, J209, J601, and J602 to the Offset Unit Assembl
y
.
6. Reinstall the Rear Cover Assembl
y
(
RRP 1.3
)
.
7. Reinstall the Fuser Full Cover
(
RRP 1.1
)
.