Service manual

QMS 3260/4032 Laser Printer - Base Engine Technical Manual 10-101
Release Version 11-97
Removal and Replacement Procedures
RRP 5.5 CRU Interlock Switch (PL 7.2)
Removal
1. Remove the EP Cartrid
g
e
(
RRP 5.2
)
.
2. Remove the Rear Cover
(
RRP 1.3
)
.
3. Disconnect J232 and J233 from the CRU Interlock Switch.
4. Disconnect J234 from the Interlock Switch wire harness.
5. Remove the screw securin
g
the CRU Interlock Switch to the printer frame, and remove the Switch.
Replacement
1. Line up the two positionin
g
holes on the CRU Interlock Switch with the two position tabs on the printer
frame.
2. Use one screw to secure the Switch to the frame.
3. Reconnect J234 to the Interlock Switch wire harness.
4. Reconnect J232 and J233 to the Interlock Switch.
5. Reinstall the Rear Cover
(
RRP 1.3
)
.
6. Reinstall the EP Cartrid
g
e
(
RRP 5.2
)
.