Service manual

QMS 3260/4032 Laser Printer - Base Engine Technical Manual 10-87
Release Version 11-97
Removal and Replacement Procedures
RRP 4.4 Registration Chute Assembly (PL 6.1))
Removal
1. Remove the Left Upper Cover Assembl
y
(
RRP 4.2
)
.
2. Remove the Re
g
istration Clutch
(
RRP 4.1
)
.
3. Remove the screw securin
g
the Inner Cover to the printer frame, and remove the Inner Cover.
4. Remove the EP Cartrid
g
e
(
RRP 5.2
)
.
5. Remove the screw securin
g
the Ma
g
net Plate to the printer frame, and remove the Plate.
6. Remove the two screws
(
under the Ma
g
net Plate
)
securin
g
the front of the Re
g
istration Chute to the
printer frame.
7. Remove the two screws
(
under the Re
g
istration Clutch
)
securin
g
the rear of the Re
g
istration Chute to
the printer frame, and remove the Chute.
8. Disconnect P/J103 from the Re
g
istration Sensor.
Replacement
1. Reconnect P/J103 to the Re
g
istration Sensor.
2. Reinstall the Re
g
istration Chute Assembl
y
into the printer frame.
Make sure the m
y
lar strip is on the outside of the Chute.
3. Ali
g
n the four screw holes
(
two at each end
)
in the Re
g
istration Chute with the four screw holes in the
printer frame.
4. Use two screws to secure the Chute to the front of the frame, and use two screws to secure the Chute
to the rear of the frame.
5. Reinstall the Ma
g
net Plate to the printer frame, and use one screw to secure the Plate.
6. Reinstall the Inner Cover to the frame, and use one screw to secure the Cover.
7. Reinstall the Left Upper Cover Assembl
y
(
RRP 4.2
)
.
8. Reinstall the Re
g
istration Clutch
(
RRP 4.1
)
.
9. Reinstall the EP Cartrid
g
e
(
RRP 5.2
)
.