Service manual

QMS 3260/4032 Laser Printer - Base Engine Technical Manual 10-81
Release Version 11-97
Removal and Replacement Procedures
RRP 4.1 Registration Clutch (PL 6.1)
Removal
1. Remove the Rear Cover
(
RRP 1.3
)
.
2. Disconnect P/J 200 from the Re
g
istration Clutch.
3. Remove the E clip securin
g
the Re
g
istration Clutch to the Re
g
istration Shaft.
4. Push out on the shaft latch as
y
ou slide the Clutch off of the shaft.
Replacement
1. Slide the Re
g
istration Clutch onto the shaft.
The shaft latch snaps the Clutch into place on the shaft.
2. Use an E clip to secure the Re
g
istration Clutch to the Re
g
istration Shaft.
3. Reconnect P/J 200 from the Re
g
istration Clutch.
4. Reinstall the Rear Cover
(
RRP 1.3
)
.