Service manual

QMS 3260/4032 Laser Printer - Base Engine Technical Manual 10-79
Release Version 11-97
Removal and Replacement Procedures
RRP 3.16 Tray 2 Take Away Sensor (PL5.2)
Removal
1. Open the Left Lower Cover.
2. S
q
ueeze in all four Sensor latches while
y
ou pull the Sensor out of the printer frame.
3. Disconnect J143 from the Sensor.
Replacement
1. Reconnect J143 to the Sensor.
2. Insert the Sensor into the cutout in the frame.
(
See the fi
g
ure for correct positionin
g)
.
3. Press in on the Sensor until it snaps into place.
4. Close the Left Lower Cover.