Service manual

QMS 3260/4032 Laser Printer - Base Engine Technical Manual 10-75
Release Version 11-97
Removal and Replacement Procedures
RRP 3.14 Left Lower Cover Pinch Roll Assembly (PL5.2)
Removal
1. Remove the Left Lower Cover Assembl
y
(
RRP 3.13
)
.
2. Remove the three screws securin
g
the Pinch Roll Bracket to the Assembl
y
, and remove the Bracket.
3. Unhook the two Pinch Roll Sprin
g
s and lift the Pinch Roll out of the Bracket.
4. Remove the two Center Bearin
g
s and the two End Bearin
g
s from the Roll.
Replacement
1. Reinstall an End Bearin
g
to each end of the Pinch Roll.
2. Reinstall the Pinch Roll onto the Bracket.
Make sure that the lip of each Bearin
g
is trapped behind the tabs in the Bracket.
3. Hook one end of each Pinch Roll Sprin
g
into a sprin
g
hole in one side of the Bracket.
4. Brin
g
the Sprin
g
s over the Pinch Roll Shaft and hook the other end of each Sprin
g
into the sprin
g
hole
on the opposite side of the Bracket.
5. Slide a Center Bearin
g
under each Pinch Roll Sprin
g
, as shown in the fi
g
ure.
6. Reinstall the Bracket onto the Left Lower Cover Assembl
y
, and use three screws to secure it to the
Assembl
y
.
7. Reinstall the Left Lower Cover Assembl
y
(
RRP 3.13
)
.