Service manual

QMS 3260/4032 Laser Printer - Base Engine Technical Manual 10-69
Release Version 11-97
Removal and Replacement Procedures
RRP 3.11 MSI No-Paper Sensor Assembly (PL4.3)
Removal
1. Remove the MSI Feeder Assembl
y
(
RRP 3.2
)
.
2. Remove the screw securin
g
the MSI No-Paper Sensor Bracket to the Feeder Assembl
y
, and lift the
Sensor Bracket off of the Feeder.
3. Disconnect the P/J from the No-Paper Sensor.
4. S
q
ueeze the Sensor latches and remove the Sensor from the Bracket.
Replacement
1. Position the Senor so the P/J connector faces the screw hole in the Sensor Bracket.
2. Insert the Sensor latches into the two openin
g
in the Bracket.
The Sensor snaps into place.
3. Make sure the arm of the No Paper Actuator is between the two arms of the Sensor.
4. Reconnect the P/J to the No-Paper Sensor.
5. Insert the Bracket pron
g
throu
g
h the ke
y
hole openin
g
in the back of the Feeder.
6. Slide the Bracket to the ri
g
ht so the screw hole in the Bracket lines up with the screw hole in the
Feeder.
7. Use one screw to secure the Bracket to the Feeder.
8. Manuall
y
actuate the No Paper Actuator to make sure it moves freel
y
between the arms of the Sensor.
9. Reinstall the MSI Feeder Assembl
y
(
RRP 3.2
)
.